Honda 2009 Pilot Owner's Manual page 280

Playing Discs (Models with navigation system)
Loading Discs in the Changer
To load multiple discs in one
operation:
1. With the ignition in the
ACCESSORY (I) or the ON (II)
position, press and hold the LOAD
button until you hear a beep and
see ''LOAD'' in the upper display,
then release the button.
2. Insert a disc into the slot. Insert it
only about halfway; the drive will
pull it in the rest of the way. You
will see ''BUSY'' in audio display.
3. When ''LOAD'' appears in the
audio display again, insert the next
disc into the slot.
Do not try to insert a disc until
''LOAD'' appears. You could
damage the audio unit.
274
4. Repeat this until all six positions
are loaded. If you are not loading
all six positions, the system will
then begin playing the last disc
loaded.
If you stop loading discs before all
six positions are filled, the system
will wait for 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
To load a single disc:
1. Press and release the LOAD
button.
2. ''NO DISC'' is shown on the screen
for an empty position in the
changer. When the green load
indicator comes on and you see
the ''LOAD'' in the audio display,
insert the disc into the slot. Insert
it only about halfway; the drive will
pull it in the rest of the way.
Do not try to insert a disc until
''LOAD'' appears. You could damage
the audio unit.
You can select the position to load a
disc. Turn the interface knob or
press a preset button to select the
position, then press ENTER on the
selector. This starts the loading
sequence. If you do not select the
position, the system loads the disc to
the first empty position in numerical
order.
If you press the LOAD button while
a disc is playing, the system will stop
playing that disc and start the
loading sequence. It will then play
the disc just loaded.