Using The Handheld Receiver For The First Time - Sangean DPR-17 User Manual

Using the handheld receiver for the first time

Battery operation
1. Remove the battery cover on the rear of the unit by pressing
the catch.
Note:
Before you insert the batteries, if you use non-rechargeable batteries,
make sure the NiMH/Alkaline switch which located inside the battery
compartment is switched to Alkaline position. If you use rechargeable
batteries, make sure to switch NiMH/Alkaline switch to NiMH position.
2. Insert four UM-1 (D size) batteries into the spaces in
the compartment.
3. Take care to ensure all batteries are inserted with correct polarity as
shown on the rear cabinet. Replace the battery cover.
4. Reduced power, distortion and a "stuttering sound" are all signs that
the batteries need replacing.
5. If the radio is not to be used for any extended period of time,
it is recommended that the batteries are removed from the radio.
Using the AC power adaptor
The AC power adaptor required for this unit should be 7.5 volts DC at
1.6 A center pin negative.
Insert the adaptor plug into the DC socket on the left side of the radio.
Plug the adaptor into a standard mains socket outlet.
Whenever the adaptor is used, the batteries are
automatically disconnected. The AC adaptor should be disconnected
from the main supply when not in use.
GB
8