Using The Standard Floorhead - Miele HS15 Operating Instructions Manual

,
Do not use the SEB 217-3
Electrobrush to clean highly variable
or uneven floors. The brush might
come into contact with the floor and
cause damage.

Using the standard floorhead

Please observe the flooring
manufacturer's cleaning and care
instructions.
In addition to the Electrobrush a
standard floorhead is supplied with
your vacuum cleaner.
This floorhead can be used for all
normal cleaning of carpets, rugs and
hard flooring which is not susceptible to
scratching.
Miele offer a range of other floorheads,
brushes and accessories for other
types of flooring and special
requirements (see "Optional
accessories").
Attach the telescopic suction tube to
the floorhead (dia. 6)
^ Push the electro telescopic suction
tube into the floorhead and turn it
clockwise or anti-clockwise until it
clicks into position.
^ To release the floorhead from the
suction tube, press the release
button.
To adjust the standard floorhead
(dia. 7)
Vacuum carpets and rugs with the
brush retracted:
^ Press the % foot control.
Clean hard flooring which is not
susceptible to scratching, as well as
flooring with gaps or deep crevices in it
with the brush protruding:
^ Press the ) foot control.
To activate the exhaust filter change
indicator
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
8):
b Active AirClean 50
c HEPA AirClean 50
^ Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 9).
^ Remove the indicator strips (dia. 10).
^ Press the exhaust filter change
indicator ~ (dia. 11).
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the display (dia. 12).
^ Close the dust compartment lid
securely, making sure it clicks into
position. Take care not to trap the
dustbag when doing so.
en
35