Signal Searching; Selecting The Aspect Ratio; Temporarily Blanking The Screen - Hitachi CP-S210 User Manual

Operating (continued)

Signal Searching

VIDEO RGB SEARCH
ASPECT AUTO BLANK
MAGNIFY VOLUME
ON
MUTE
OFF
FREEZE KEYSTONE
NOTE
• May not function properly with some input signals.
• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

VIDEO RGB SEARCH
ASPECT AUTO BLANK
MAGNIFY VOLUME
ON
MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
ENTER
ESC RESET

Temporarily Blanking The Screen

VIDEO RGB SEARCH
ASPECT AUTO BLANK
VOLUME
MAGNIFY
ON
NOTE
• The temporarily blanking function will automatically finish if either the STANDBY/ON, SEARCH,
RGB, VIDEO, FREEZE, AUTO, VOLUME, MUTE, POSITION or MENU button of remote control is pressed, or if
a button of projector is pressed, or if there is a change in the input signal's state.
Downloaded From projector-manual.com Hitachi Manuals
Press the SEARCH button.
1
Cycle through input signals, displaying the images of retrieved signals. If
no signal is found, returns to the signal that was selected before the search
was begun.
RGB VIDEO
COMPONENT VIDEO
Press the ASPECT button.
1
RGB input
4:3 16:9
• At a RGB input, selecting an aspect ratio may display the message
"SYNC IS OUT OF RANGE". In this case, please select one of other
aspect ratios.
VIDEO, S-VIDEO, COMPONENT VIDEO input
4:3 16:9
• At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i
(1035i/1080i)/750p, only 16:9 can be selected.
• When the 4:3 is selected under the SCREEN TYPE item of the OPTION
menu. WIDE and ZOOM cannot be selected.
Press the BLANK button.
1
The input signal screen is shut off, and a blank screen appears. You can
set the blank screen using the menu (from the SCREEN menu,
select BLANK).
Press the BLANK button again to remove the blank screen,
and return to the input signal screen.
S-VIDEO
15:9 32:15
WIDE ZOOM
SEARCH
ASPECT
BLANK
21