Whirlpool Washer Installation Instructions page 3

Now start.. .
Firmly grasp the body of the wasner
and carefully tilt the washer backward
so that the front of the washer IS 3-4
Inches oil the floor Insert a prece of
wood as a brace to hold the washer 1"
Use legs and nuts from parts
tram plastrc covered base
W Screw the front legs Into holes
at the front corners of the washer.
Turn legs until nuts touch washer base
[Do not trghten nuts yet ]
4
n
Tilt washer backward slightly
and remove the piece of wood. Gently
lower washer front
Estimate how far
/-
/
- I/Cutthehosetc
4 ris permanent place
/-,, ,&/ thatlength. ~1
over the dram
hose. Push the
hose on the connector Slrde the hose
clamp down over the hose connector
DO NOT KINK HOSES
off each side of cabinet Cut me
Place contents of lrlerofure
pockage here
washer prclured from the back
two pieces of tape located at the
bottom rear of the washer This WIII
release the self-levelrng legs