GE MultiLink ML1600 Quick Start Manual page 55

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE
Enter the path to the folder in which the configuration file will be
stored
Select Xmodem as the receiving protocol.
Enter a name for the configuration file.
Click OK.
The configuration file will be stored at the specified location.
Verify that the configuration file has been created and stored
correctly.
This completes the Save (original) Configuration procedure.
The following procedure describes how to upgrade the firmware:
If the current firmware is older than 1.7.3, use the upgrade
command:
ML1600/2400# upgrade mode=serial
Do you wish to upgrade the image? [Y or N]
See figure below.
If the current firmware is older than 1.7.3, use the xmodem
command:
ML1600/2400# Xmodem get type=app
QUICK START GUIDE
Y
QS–51