GE MultiLink ML1600 Quick Start Manual page 16

QUICK START GUIDE
QS–12
connected together while pin 2 at one end is connected to pin 3 at the other end. Once you
have obtained a cable with this pin configuration, connect one end to the computer's
serial port and the other to the Multilink switch port.
The Hyperterminal utility application is a convenient standard firmware tool that will be
used to configure the switch. This program is found on most windows based operating
systems under programs > accessories > communications > Hyperterminal.
Once the HyperTerminal application is launched you will need to
cancel HyperTerminal's dial sequence by left mouse clicking on the
Cancel pushbutton. This will allow you to access Hyperterminal's
configuration menus.
MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE