Uv Light Bulb; Removing The Rechargeable Battery - Philips HealthyWhite Rechargeable Sonic toothbrush User Manual

EngliSH
1
the cord wrap (select models) to store the power
cord in an organized manner.
- You can store brush heads on the pegs at the
back of the charger.
Replacement
Brush head
- Replace Sonicare brush heads every 3 months to
achieve optimal results.
- Use only compatible Sonicare replacement brush
heads.

UV light bulb

- Replacement UV bulbs are available through
your Sonicare Consumer Care Center in North
America by calling 1-800-682-7664. Outside
North America, contact your local Philips
Consumer Care Center.
Disposal
- At the end of product life and prior to disposal,
please remove the rechargeable battery from the
handle by following the instructions below.
- Do not throw away the appliance or the UV light
bulb (bulb contains mercury) with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling. By
doing this, you help to preserve the environment.
- The built-in rechargeable battery contains
substances that may pollute the environment.
Always remove the battery before you discard
the appliance, and recycle or dispose of the
battery according to local waste management
requirements.
- If you have any recycling questions, contact your
local waste management office.

Removing the rechargeable battery

Please note that this process is not reversible.
- To remove the rechargeable battery, you need a
flat-head (standard) screwdriver. Observe basic
safety precautions when you follow the procedure
outlined below. Be sure to protect your eyes,
hands, fingers, and the surface on which you work.
1 To deplete the rechargeable battery of any
charge, remove the handle from the charger,
turn on the Sonicare and let it run until it
stops. Repeat this step until you can no longer
switch on the Sonicare.
 Insert a screwdriver into the slot
located at the bottom of the handle and
turn counterclockwise to release the bottom
cap.
 Hold the handle upside down and push
down on the shaft to release the internal
components of the handle.
 Insert the screwdriver under the circuit board,
next to the battery connections, and twist to
break the connections. Remove the circuit
board and pry the battery from the plastic
carrier.
The rechargeable battery can now be recycled or
disposed of and the rest of the product discarded
appropriately.
EngliSH
1