Black & Decker BDC8L-LA Instruction Manual page 14

14 • ENGLISH
Fault
Your cooler does not function
(plug is inserted, LED does not glow
after sliding the switch to cool or
heat).
Your cooler does not cool (plug
is inserted, LED glows).
Your cooler does not heat (plug
is inserted, LED glows).
Operation with a 12V socket
(Cigarette Lighter): The ignition
is on and the cooler is not working.
Pull the plug out of the socket and
make the following checks.
TROUBLESHOOTING
Possible Cause
There is no voltage flowing
from the 12V socket (cigarette
lighter) in your vehicle.
The inner fan or the cooling
element is defective.
The inner fan or the heating
element is defective.
The cigarette lighter socket is
dirty. This results in a poor electrical
contact. The fuse of the 12V plug has
blown. The vehicle fuse has blown.
Solution
The ignition must be switched
on in most vehicles for voltage
to flow at the cigarette lighter.
Try using another plug socket.
This can only be repaired by an
authorised customer services unit.
This can only be repaired by an
authorised customer services unit.
If the plug of your cooler becomes
very warm in the cigarette lighter
socket, either the socket must be
cleaned or the plug has not been
assembled correctly. Replace the
fuse (10A) in the 12V plug. Replace
the vehicle's 12V socket fuse (usually
15A). (Please refer to the operating
manual of your vehicle)