Installation; Operation - DeWalt DXPW1200E Instruction Manual

SAVE THESE INSTRUCTIONS
FOR FUTURE USE

INSTALLATION

1. Place handle (G) onto frame (F) and secure
with saddle bolts and knobs (R).
CAUTION: Risk of personal injury. Avoid
placing hands between handle and frame when
assembling to prevent pinching.
2. Attach high-pressure hose (H) to spray gun
(C). Make sure it is secure.
3. Connect wand (E) to spray gun (C). Make sure
connection is secure.
C
H
4. Place the nozzle holder (B) onto the panel assembly (A) and push
each nozzle holder into place.
5. Remove the five
colored quick-
connect nozzles from
the plastic bag and
A
insert them into
correct grommet on
the nozzle holder. Nozzles are color coded to match colored nozzles
on panel assembly.
G
F
R
E
C
B
NOTE: The high-pressure pump was filled with oil at the factory.
Always check oil level before using (refer to Maintenance for more
information).
WARNING: Risk of bursting. Use a tire pressure gauge to check the
tires pressure before each use and while inflating tires; see the tire sidewall
for the correct tire pressure.
NOTE: Air tanks, compressors and similar equipment used to inflate
tires can fill small tires similar to these very rapidly. Adjust pressure
regulator on air supply to no more than the rating of the tire pressure.
Add air in small increments and frequently use the tire gauge to
prevent over inflation.

OPERATION

The pressure setting is preset at the factory to achieve op ti mum
pressure and cleaning. To lower the pres sure, follow these instructions.
1. Back away from the sur face to be cleaned. The further away you
are, the less the pressure will be on the surface to be cleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a less
powerful stream of water and a wider spray pattern. Refer to
Spray Wand Nozzles.
3. Water pressure can be varied by turning the pressure adjusting
knob (L) clockwise to increase pressure and counterclockwise to
decrease pressure.
NOTICE: DO NOT attempt to increase pump pressure. A higher
pressure setting than the factory set pressure may damage pump.
The nozzles for the spray wand are stored in the nozzle holder (B) on the
panel assembly (A). Colors on the panel identify nozzle location and spray
pattern. Refer to the following chart to choose the correct nozzle for
the job to be performed.
6