Download Print this page

KitchenAid KD-100 Installation Instructions

Value disposers

Advertisement

Quick Links

KitchenAid,
VALUE DISPOSERS
MODELS KWC=200B, KD-200
KD-100
INSTALLATION INSTRUCTIONS
INSTALLER:
FINAL
CHECK
LIST
GE.RlcL
emove unit from
carton
and check for shipping
damage.
0
2. Sink flange
assembled
in center
of drain opening
and tightly
sealed.
0
3. Disposer
level - not installed
at an angle.
0
4. If a dishwasher
drain
is connected
into the disposer,
check to assure that
the inlet knockout
has been removed.
PLUMBING
0
1. If installed
in old house, existing
drain
line from
sink to sewer cleaned.
0
2. Long, horizontal
drain
lines eliminated.
0
3. Drum
traps and grease traps should
not be used.
0
4. Seal at drain
spout
properly
positioned.
0
5. Center
line height
of drain
line must not exceed
center
line height
of
disposer
discharge
opening.
0
6. M oun mg screws and spout screws properly
tightened
to prevent
leaks.
t'
0
7. Compliance
with
all aspects of local plumbing
code.
ELECTRICAL
CONNECTION
0
1. Properly
fused,
115 volt,
60 hertz branch
circuit
of 15 ampere
capacity.
0
2. Disposer
properly
grounded
before
operating.
0
3. All connections
must comply
with
the National
Electrical
Code and/or
local electrical
code.
OPERATIONAL
0
1. Before
operating,
check to assure grind chamber
is free of any foreign
objects.
0
2. Activate
disposer
-test
for grinding
performance
and water
leaks.
THANK
YOU
INSTALLER:
1. Complete
Installation
Check
List.
2. Leave all literature
(including
Check
List) for customer.
3. Notify
dealer that electrical
work
and plumbing
are completed.

Advertisement

loading

Summary of Contents for KitchenAid KD-100

  • Page 1 KitchenAid, VALUE DISPOSERS MODELS KWC=200B, KD-200 KD-100 INSTALLATION INSTRUCTIONS INSTALLER: FINAL GE.RlcL emove unit from carton and check for shipping 2. Sink flange assembled in center 3. Disposer level - not installed at an angle. 4. If a dishwasher drain...
  • Page 2 1. Use a small cold chisel or punch to cut out the back wall knockout washer inlet boss of the disposer. 2. Turn the disposer upside down to remove any pieces or chips from the grinding chamber. 3. KD-100, KD-200. & KWC-2OOB MODELS 3/4”...
  • Page 3 DISPOSER INSTALLATION 1. Be sure the isolating splash guard (8) is in place. Lift disposer and engage hooh (7) onto support plate (4), then engage hook (11) onto support plate (4). Turn disposer to align with drain trap. Snap lever (10) downward 2.
  • Page 4 COI~~~C~~~IS ment-Frounding terminal or lead on Lile appliance. KITCHENAID DIVISION \HOBART/ FORM 14609A (1 l-83) J/7 7459 POWER SUPPLY AT THE FUSE/ ELECTRICAL CONNECTIONS. of l/2 HP. motor. (Switch not from the control switch to the disposer below).

This manual is also suitable for:

Kd-200Kwc-200b