Removal From Storage; Battery - Bush Hog TH420 Operator's Manual

8. Tie a plastic bag over the exhaust pipe and air cleaner inlet to
prevent moisture or small animals or insects from entering.
9. Cover the vehicle with a canvas cover. Do not use plastic or
coated materials since they do not allow ventilation for the vehicle.

Removal From Storage

1. Check the battery electrolyte level and charge the battery if nec-
essary. Install it in the vehicle.
2. Make sure the spark plug is tight.
3. Fill the tank with fuel.
4. Check all the points listed in the Pre-Ride Inspection section on
page 29.
NOTE: Tightness of the bolts, nuts, and other fasteners should be
checked by an authorized Bush Hog dealer.
5. Lubricate as outlined in the Periodic Maintenance Schedule.

Battery

Keep the battery terminals and connections free of corrosion. If clean-
ing is necessary, remove the corrosion with a stiff wire brush. Wash
with a solution of one tablespoon of baking soda and one cup of water.
Rinse well with tap water and dry off with clean shop towels. Coat the
terminals with dielectric grease or petroleum jelly.
Be careful not to allow cleaning solution or tap water into the battery.
BATTERY ELECTROLYTE IS POISONOUS. IT CONTAINS
SULFURIC ACID. SERIOUS BURNS CAN RESULT FROM
CONTACT WITH SKIN, EYES OR CLOTHING.
Antidote
External: Flush with water
Internal: Drink large quantities of water or milk. Follow with milk of
magnesia, beaten egg, or vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get prompt medical attention.
WARNING
67