Advertisement
Installation 2:
1. Locate suitable mounting location at rear of vehicle.
2. Use the supplied mounting template to mark the mounting hole locations.
3. Drill two 3/16 inch holes for mounting.
4. Use screws provided to attach the camera backboard to the vehicle with the lens
shroud on topside.
5. The camera cable can be routed through an existing grommet or use a location
where a 11/16 inch hole can be drilled. Be sure to check behind intended drilling
location. Check for interference with license plate lights, hatch release switch
and/or mechanism. If not using an existing factory grommet, drill a 11/16inch hole
at the selected location. Coat edge of hole with rust preventative. Route the camera
cable connector through the hole and insert grommet into hole.
7
Advertisement
