Advertisement
Installation 1:
1. Locate suitable mounting location at rear of vehicle.
2. Use the camera mounting bracket as a template to mark the mounting hole
locations.
3. Drill two 3/16 inch holes.
4. Attach the camera-mounting bracket to the vehicle with the lens shroud on topside.
If lens shroud is on the bottom, then the camera must be removed from the bracket
and turned 180 degrees and then reattached to the bracket.
5. The camera cable can be routed through an existing grommet or use a location
where a 11/16 inch hole can be drilled. Be sure to check behind intended drilling
location. Check for interference with license plate lights, hatch release switch
and/or mechanism. If not using an existing factory grommet, drill a 11/16 inch
hole at the selected location. Coat edge of hole with rust preventative. Route the
camera cable connector through the hole and insert grommet into hole.
4
Advertisement
