Installation Instructions Model CMOS1 Camera (V2.0) FEATURES: High Resolution 1/4'' CMOS Color Camera ● Compact Zinc Alloy Die Cast Body ● Waterproof Housing ● Waterproof Microphone ● Adjustable Mounting Angle ● Wide Angle Lens ● Selectable Normal or Reverse Image...
Page 4
Camera Installation 1 (Viewing angle is adjustable)
Page 5
Installation 1: 1. Locate suitable mounting location at rear of vehicle. 2. Use the camera mounting bracket as a template to mark the mounting hole locations. 3. Drill two 3/16 inch holes. 4. Attach the camera-mounting bracket to the vehicle with the lens shroud on topside. If lens shroud is on the bottom, then the camera must be removed from the bracket and turned 180 degrees and then reattached to the bracket.
Page 6
6. The camera cable to the extension cable connect as described below: A. Yellow RCA- connect to Video (Camera Yellow RCA) B. White RCA- connect to audio (Camera White RCA) C. Camera red wire- connect to reverse lamp 12V voltage D.
Page 7
Camera Installation 2 (Viewing angle does not adjust)
Page 8
Installation 2: 1. Locate suitable mounting location at rear of vehicle. 2. Use the supplied mounting template to mark the mounting hole locations. 3. Drill two 3/16 inch holes for mounting. 4. Use screws provided to attach the camera backboard to the vehicle with the lens shroud on topside.
Page 9
6. The camera cable to the extension cable connect as described below: A. Yellow RCA- connect to Video (Camera Yellow RCA) B. White RCA- connect to audio (Camera White RCA) C. Camera red wire- connect to reverse lamp 12V voltage D.