Table of Contents
Advertisement
Accessories
SUPPUED:
(1) Belt Clip
(1) Carrying Case (PIN GMRGPS-CS)
OPTIONAL:
(1) Desktop Charger (PIN GMRGPS-SC) and
AC/DC Wall Adapter (PIN GMRGPS-WA)
(1) Vehicle Cigarette Lighter Battery Eliminator
(DC12V-to-DC 6V) (PIN GMRGPS-BE)
(1) Car Mounting Bracket (PIN GMRGPS-CB)
(1) Headset (PIN FRS-SHSn
(1) Set of Rechargeable Batteries
Powering the GMR-GPS Unit:
SPAING
CUPS
SPRING LOADED
BELTCUP
Belt Clip Accessory
Your GMR-GPS unit operates on four AA batteries. Alkaline batteries will provide slightly better
performance than rechargeable
batteries.
Only Audiovox-approved rechargeable batteries can be
recharged in the unit using the optional
charger.
This will ensure optimum pertormance for the
GMR-GPS.
Use of the AudiOvox charger with other brands of batteries is not recommended, as
battery charging times will
vary.
Refer
to the manufacturer's instructions for charging
other
brands of
batteries.
Installing the Balteries:
Installing batteries in the GMR-GPS unit is straightforward as shown in
the
illustration
below.
1.
Simply unlatch the cover clip at the bottom rear of the unit and lift off the battery compartment
cover_
2.
Remove the four discharged
batteries,
if
present,
unless the unit is being used for the first
time.
3.
Install four rechargeable AA
batteries,
or install Alkaline batteries, if desired. Carefully note
battery polarity as marked within the battery compartment.
4.
Slide the battery compartment cover in place; swing up the cover retaining clip and snap it
into position.
BATTERY
COMPARTMENT
COVER
COVER
CLIP (SWING
DOWN)
. .
Battery Installation and Removal
8
BATTERY
COMPARTMENT
(OBSERVE
POLARITY)
Advertisement
Table of Contents
