Table of Contents
Advertisement
Releasing the button allows the unit to revert to GMRS standby
mode.
When receiving an
Incoming
signal, the Monitor icon will
be
highlighted
and
depict Ihe relative strenth of the signal.
The PTI Button
can
also be
used as
a two-way call ringer. Pressing the button twice quickty will call
another party on
the
same channel. The TX
icon
will be highlighted for approximately 3 seconds
and then go out.
External Sp.akar
(SPK)lMlcrophone (MIC) Jack (5)
This
jack
accepts an optional Audiovox headset/microphone connector (Part No. FRS-BHST) to
provide hands-free GMRS
operation.
ACCESSING THE RADIO
SETUP
FUNCTIONS
Prior to using
the
radio
feature
of your
GMR-GPS
unit,
the operating parameters must
be
set
up
to
establlsh basic
operating
modes,
such
as channel
scan, VOX
operation.
Aoger Beep tone on/off,
and
call
melody
selection.
To establish these parameters, proceed as follows:
1.
Access
the
SETUP display and, using
the
UpIDown wheel
key,
highlight RADIO; then press Enter. The following screen appears
with
DUAL
CH
highlighted;
DUAL
CH is also highlighted
In the
function bar below the menu.
2.
Press
the Enter button; a menu appears in the lower center
of the display with
01
highlighted. Press the Up!Down wheel
key
to
highlight one 01 15 (01-15) secondary or dual radio channels
desired; then press Enter to
select.
3.
Using the
UpIOown
wheel
key,
select the
CALL
MELODY desired
(OFF or
01-(9).
When the menu
appears,
the
culTent call melody
number (or
OFF)
is highlighted and the melody plays a short excerpt.
As you scroll through each melody number, the melody plays an
excerpt for approval. Hlghlightthe desired number (or
OFF)
and press
Enter.
4. Using the Up/Oown wheel key, highlight the VOX
DELAY Item
and press
Enter lor selection 01 the VOX
DELAY
l
unction
(OFF,
1-4 SEC).
5.
Using the UpIDown wheel
key,
highlight
the
ROGER BEEP item and
press Enter for selection of the ROGER
BEEP
lone
ON or
OFF.
6.
Using the UpIOown wheel
key,
highlight the SQ TAIL (Squelch Tail) item
and press Enter for selection of the Squelch Tail
ON
or
OFF.
PRESS
ENTER
NOTE: Whenever you transmit, the receiving party (on the same channel) will hear the
short buzz. referred
to
8S
the "Squelch Tair, when you finish the
transmission
.
The
unit
can
be
set
to
suppress (quiet) this
noise
by using the
SQ
TAIL
ON
option.
41
Advertisement
Table of Contents
