Drive Chain Lubrication; Inspection And Maintenance Of Battery - Sym Symba 110 MB10A7 Series User Manual

DRIVE CHAIN ADJUSTMENT
Check the drive chain for wear and tension. If it appears dry,
apply a lubricant.
 Place the scooter on the main stand. Shift the transmission into
neutral.
 Move the chain up with your fingers at a point midway between the
sprockets. Adjust slack so that it is approx. 10~20 mm (1/2~1/3 in).

INSPECTION AND MAINTENANCE OF BATTERY

 Inspecting and maintenance of the electrolyte level should be
performed at the mileage intervals indicated in the maintenance
schedule. For pre-riding inspection, the electrolyte level must be
maintained between the upper and lower level marks. If low, add
distilled water to raise the levels. Use a syringe or plastic funnel.
The battery is accessible by removing the side cover.
CAUTION:
 When installing the battery, route the battery breather tube
as shown in the figure and be careful not to bend or twist the
tube.
 Battery specification: 12 V 5 Ah.
Cleaning of battery terminals
Remove the battery terminals and clean if there is dirt and corrosion present.
Battery removal procedures are as follows:
Turn ignition switch "OFF", then open the battery cabinet door, then remove negative cable screw first
and disconnect the negative cable. Then remove positive cable screw and positive cable.
NOTICE:
 Clean the battery posts with warm water if the posts are corroded and have some white powder on
them.
 If there is obvious corrosion on the terminals, then disconnect the cables, clean the corrosion off with a
steel brush or a piece of sandpaper.
 Install battery cable after cleaning and apply a thin coat of grease on the terminals.
 Install battery in reverse order of removal.
10~20 mm
(1/3~1/2 IN)
Upper
Lower
Negative
10. Inspection and maintenance before riding
Positive
17