Table of Contents
Advertisement
By default, the selection focus should be on "Channel 1' on the Channel List. The
side bar is basically divided into three sections. At any point, you can use the
"Left" or "Right" button on the remote to quickly move to each section.
For example, if the selection focus is currently on "Channel 1" (or anywhere in
the section "1"), press the "Left" button on the remote will move the focus to the
"Manual recording" icon in section "2". Simply use the "Up" and "Down" buttons
on the remote to move between icons in one particular section.
Use the "Up" and "Down" buttons on the remote to select a channel on the
"Channel List" and press the "ENTER" button on the remote to make the selection.
Alternatively, if a USB mouse is connected to the NVR, you can use the mouse
and move the cursor to a channel and left-click to make the selection.
You can also use the channel selection buttons on the remote to quickly jump to
a desired channel.
The small dots on the side of the "Channel List" provide the current status of
each channel:
* White: Disconnected
* Blue: Connected
* Green: Recording
* Dark grey: Not configured
7.1.5 Sequence view
If the current selection focus is on "Channel 4", press the "Down" button on the
remote should move the focus to the "Sequence viewing" icon. Press the "ENTER"
80
Advertisement
Table of Contents
