Advertisement
InstAllAtIon InstRUctIons - GAs
levelling Your cooker
Place a spirit level on a baking sheet onto
an oven shelf.
The cooker is fitted with LEVELLING FEET
(1). Level your cooker to your desired
height using the levelling feet at the front
and rear of the cooker. A minimum clear-
ance of 15mm is essential for clean air
supply.
stability bracket
The stability bracket provided must be
fitted to the back of the cooker and fitted
as follows:
Place the cooker in position and draw a
PENCIL LINE level with the front edge (2).
Mark the centre of the cooker to give a
CENTRE LINE (3).
Remove the cooker and mark off 200mm
to the right of the centre line (4) on the
rear wall.
Measure from FLOOR LEVEL to the
ENGAGEMENT EDGE where the stability
bracket will rest and add 2mm (5).
Transfer this dimension to the rear wall
and secure the bracket to the wall at this
height (6) using the two off centre holes
in the single bracket.
Advertisement
