Chevrolet 2013 Malibu Owner's Manual page 39

When all additional transmitters
are programmed, press and
hold the START button for
10 seconds to exit
programming mode.
Programming without a
Recognized Transmitter (Keyless
Access Vehicles Only)
If there are no currently recognized
transmitters available, follow this
procedure to program up to eight
transmitters. This feature is not
available in Canada. This procedure
will take approximately 30 minutes
to complete. The vehicle must be off
and all of the transmitters to be
programmed must be with you.
1. Insert the vehicle key of the
transmitter into the key lock
cylinder on the outside of the
driver door and turn the key to
the unlock position five times
within 10 seconds.
The Driver Information Center
(DIC) displays REMOTE LEARN
PENDING, PLEASE WAIT.
2. Wait for 10 minutes until the
DIC displays PRESS ENGINE
START BUTTON TO LEARN
and then press the START
button.
The DIC displays will again
show REMOTE LEARN
PENDING, PLEASE WAIT.
3. Repeat Step 2 two additional
times. After the third time, all
previously known transmitters
will no longer work with the
vehicle. Remaining transmitters
can be relearned during the next
steps.
The DIC display should
now show READY FOR
REMOTE # 1.
Keys, Doors, and Windows
4. Place the new transmitter into
the transmitter pocket, which is
inside the center console
storage area.
5. Press the START button. When
the transmitter is learned the
DIC will show that it is ready to
program the next transmitter.
6. Remove the transmitter from the
transmitter pocket and press
To program additional
transmitters, repeat Steps 4 6.
2-7
.