Chevrolet 2013 Malibu Owner's Manual page 299

5. Disengage the spring clip (2)
from the bulb by pressing down
on the end and then swing
upward.
6. Remove the bulb from the lamp
assembly.
7. Install a new bulb in the lamp
assembly.
8. Install the spring clip (2).
9. Connect the electrical
connector (1).
10. Replace the cap from the back
of the headlamp assembly by
turning it clockwise.
11. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it
straight into the bottle. Ensure
that the filler neck clip engages
into the underhood electrical
center retainer.
Low-Beam Headlamp
1. For the driver side bulb, remove
the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.
2. Remove the cap from the back
of the headlamp assembly by
turning it counterclockwise.
3. Disconnect the electrical
connector.
4. Remove the bulb from the lamp
assembly by turning
counterclockwise.
5. Install a new bulb in the lamp
assembly.
6. Connect the electrical connector.
7. Replace the cap from the back
of the headlamp assembly by
turning it clockwise.
Vehicle Care
8. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it straight
into the bottle. Ensure that the
filler neck clip engages into the
underhood electrical center
retainer.
HID Headlamp Assembly
The HID assembly has a high
intensity discharge (HID) high/low
beam, a DRL/parking lamp,
sidemarker lamp, and a turn signal
lamp on the headlamp assembly.
For replacement of the headlamp on
an HID assembly, contact your
dealer. See High Intensity
Discharge (HID) Lighting on
page 10 29.
10-31