SENDO Cell Phone User Manual page 10

3
To remove press up on the tabs on the left
side of the battery and lift out.
1 You must charge the battery for at least
12 hours before using the telephone for
the first time.
2 Allow your battery to fully discharge
occasionally before recharging it.
3 When the battery is completely
discharged it may take some time for the
battery charging icon to appear after you
have connected the charger.
If you remove your battery you will find the
phone's label on the back portion of the
phone. This label includes information about
the phone, such as the model number.
Do not remove the phone's label. In the
unlikely event that you ever need to make a
warranty claim or seek assistance with
respect to use of your phone, you may be
asked for this information.
ζ
Note: Always turn your phone off before
you insert or remove the battery.
Charging the battery
Insert the connector on the charger lead into
the connector on the top left of the phone.
Plug the charger into a mains AC socket.
When charging commences, the battery
icon will change into a charger cable icon.
When the battery is fully charged, the
battery icon will reappear and you can
disconnect the charger.
The battery will normally take around 2 to 3
hours to charge.
Charging and Discharging
A new battery's full performance is achieved
only after two or three complete charge and
discharge cycles. The operation times
provided are reasonable estimates and may
be affected by network conditions, charging
and phone usage.
The battery can be charged and
discharged hundreds of times but it will
eventually wear out. When the operating
time (talk time and standby time) is
noticeably shorter than normal, it is time to
buy a new battery.
Use only batteries approved by Sendo and
recharge your battery only with the chargers
approved by Sendo. When a charger is not
in use, disconnect it from the power source.
Do not leave the battery connected after its
9