LiteHawk Whisper 30180 Instruction Manual page 4

LiteHawk Whisper - Transmitter & Receiver Binding
The binding process effectively ties the transmitter and
receiver together. Under normal circumstances, both items
are supplied like this from the factory. If, however, you find
that your transmitter and receiver are not bound (receiver's
red LED will turn on), you should do the following:
1. Make sure throttle stick (Left Stick) is in the bottom
position, turn on the transmitter.
2. Carefully pull the receiver unit (which is in the front of the
boat), so that you can see the BIND button.
3. Switch on receiver (BATTERY BOX IS TURNED ON - FRESH
BATTERIES IN BATTERY BOX).
4. Press the BIND button. The receiver light will turn GREEN.
6. Replace the receiver in the boat along with the battery box.
7. Ensure the antennea wire is AWAY from batteries.
LiteHawk Whisper - Before Sailing
Always turn the transmitter ON before turning ON the boat's AAA battery box. Likewise, turn OFF the boat's battery
box before turning OFF the transmitter.
LiteHawk Whisper - Controls
1. When the left stick is in position A, the main boom and jib boom will be in position A. Likewise, when the
left stick is in position B, the main boom and jib boom will be in position B.
2. You can adjust the sail servo trim by clicking the up and down trim buttons for the left stick.
3. The rudder control is on the right stick. The rudder will turn to the left when the right stick is pushed to the
left. Likewise, the rudder will turn to the right when the right stick is pushed to the right.
4. You can adjust the rudder servo trim by clicking the left and right trim buttons for the right stick.
Sail Control Stick
B
A
Sail Control Trim Buttons
LITEHAW LIT AWK
B
A
www.litehawk.ca
Rudder Control Stick
L R
Rudder Control Trim Buttons
B
A
R