Preparation; Troubleshooting - Lifepro LS1002THD14 User Manual

PREPARATION

Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet and turn
on the power switch on the rear of the unit . Only operate heater in upright position .
Insert one CR2025 battery into the remote control before using (battery inluded .)
Please note that infrared heaters do not heat like a traditional space heater . You should not expect
infrared heaters to blow hot air like a traditional space heater . Infrared heaters heat objects not air .
Infrared heaters are intended to supplement an already heated, insulated room . Square footage
specifications assume a single enclosed room not an entire home . Infrared heaters do not heat
through walls, floors, and are not intended to replace a main heat source . Infrared heat can take at
least 24 hours to warm a room but operate much more efficiently to maintain the desired temperature .
Infrared heaters will not work well in uninsulated unheated spaces like screened in porches, RV's,
garages, unheated basements, etc .

TROUBLESHOOTING

PROBLEM
The heater does not
turn on .
The heater displays an
error code "E3"
POSSIBLE CAUSE
1 . The power cord is not plugged in .
2 . The electricity at the main fuse box is
not working .
3 . The battery in the remote control is
dead .
4 . The thermostat on the heater is set
lower than the room temperature .
1 . Temperature sensor not functioning
properly .
CORRECTIVE ACTION
1 . Plug the power cord into an electrical outlet .
2 . Check the electricity at the main fuse box .
3 . Replace the batteries in the remote control .
4 . Increase the thermostat temperature on the
heater for a higher heat setting .
1 . Please contact technical support .
8