Table of Contents
Advertisement
PREPARATION
Plug the heater into a grounded 120 V, 60 Hz power outlet. Only operate heater in upright position.
Please note that infrared heaters do not heat like a traditional space heater. You should not expect
infrared heaters to blow hot air like a traditional space heater. Infrared heaters heat objects not air.
Infrared heaters are intended to supplement an already heated, insulated room. Square footage
specifications assume a single enclosed room not an entire home. Infrared heaters do not heat
through walls, floors, and are not intended to replace a main heat source. Infrared heat can take at
least 24 hours to warm a room but operate much more efficiently to maintain the desired temperature.
Infrared heaters will not work well in uninsulated unheated spaces like screened in porches, RV's,
garages, unheated basements, etc.
TROUBLESHOOTING
PROBLEM
The heater does not
turn on.
There is no heat
If the unit shuts down
POSSIBLE CAUSE
1. The heater is not plugged in.
2. The power switch is not on.
3. The electricity at the main fuse box is
not working.
4. The thermostat on the heater is set
lower than the room temperature.
1. The temperature needs to be increased
on the heater.
1. There was a power outage.
2. The unit overheats.
CORRECTIVE ACTION
1. Plug the heater into a dedicated outlet.
2. Flip the master power switch to the on
position.
3. Check the electricity at the main fuse box.
4. Increase the thermostat temperature on the
heater for a higher heat setting.
1. Increase the temperature on the heater.
1. Turn the power switch to off then turn power
switch to on.
2. Unplug the unit and wait 5-10 minutes, then
plug in and turn power switch to on.
8
Advertisement
Table of Contents
