Subscribe to Our Youtube Channel
Related Manuals for FireBird 16" Multifueld Backboiler Inset Stove
Summary of Contents for FireBird 16" Multifueld Backboiler Inset Stove
- Page 1 Multifuel Backboiler Inset Stove Instruction Manual All the comfort of a stove with the bene t of heat to your house.
-
Page 2: Table Of Contents
INDEX Page INTRODUCTION ..................IMPORTANT SAFETY NOTES ............... TERMS & CONDITIONS OF GUARANTEE ........INSTAllATION INSTRUCTIONS Performance ..................Health and Safety ................Air Supply ..................Fireplace ..................... Hearth ....................Chimney/Flue .................. Installing and Back Filling ............Heating and Hot Water System .......... -
Page 3: Introduction
1.0 INTRODUCTION We would like to thank you for purchasing a high efficiency, Firebird multifuel backboiler inset stove (hereinafter referred to as “the inset stove”). The design for this product stems from our original concept, “the Firebird backboiler”. The stove is manufactured in its entirety in our factory in Baile Mhic Íre, Macroom, Co. -
Page 4: Terms & Conditions Of Guarantee
(d) Installation of the inset stove must be in accordance with this manual and all relevant standards and codes of practice. (e) Firebird can accept no liability in respect of any defect arising from incorrect installation, negligence, fair wear and tear, misuse, alteration or repair by unqualified persons. -
Page 5: Installation Instruction
4.0 INSTALLATION INSTRUCTION PERFORMANCE The following highlights the output and test performance of the inset stove: Firebird 16” Multifuel Backboiler Inset Stove Fuel Type Wood Ancit Ancit Output to Water - kW Output to Space - kW Efficiency - % 75.0 79.9 81.5 CO (@13% O 0.61 0.36 0.44 BS Standard... -
Page 6: Health And Safety
NOTE: No extractor fan should be fitted in NOTE: If your Firebird inset stove is not the same room as the appliance. installed, operated and maintained properly a house fire may result! -
Page 7: Hearth
The appliance must be installed on a pipe. This avoids possible fire risk. hearth that can take the weight and is of a Firebird recommend that a thorough non-combustible material. inspection of the chimney is carried out Ensure that when installing the appliance,... -
Page 8: Installing And Back Filling
Flues should not pass through ceilings, the materials used for back filling are floors or any form of combustible walls non-combustible. without adequate, approved insulation 7. An expansion pipe must be fitted to having been installed, to protect the the inset stove water outlet pipe, combustible material. which must be vented to atmosphere, above the height of the header tank. -
Page 9: Typical Installation
Fireplace surround Inset stove Inset facia Fixing screws for 16" inset min 350 mm for 18" inset min 400 mm min 415 Typical installation to open door limiting dimensions of hearth... - Page 10 TYPICAl SCHEMATICS Open vent 22 mm Open vent 22 mm Overflow Overflow Cold water Feed and expansion tank tank Domestic hot water draw off Gravity radiator Drain cock Gravity return 28 mm Indirect hot water cylinder Minimum return thermostat Gravity flow 28 mm Central heating flow Circulating pump Back...
-
Page 11: Heating And Hot Water System
HEATING AND HOT 4.10 CHECKS BEFORE lIGHTING WATER SYSTEM Note: Prior to lighting the inset stove, The central heating system must comply with BS5449 part 1. allow sufficient time for the back fill to dry The hot water cylinder must be indirect at normal conditions. -
Page 12: Operating Instructions
OPERATING of time. INSTRUCTIONS Air dried wood should be seasoned for at least 12 months before burning. FUElS HEATAS Ltd. approval covers the burning of Wood that has been contaminated or the following smokeless fuels in this inset treated with varnish, paint or other stove: coatings and preservatives, should not be • Ancit. -
Page 13: Smokeless Fuel
Fully open out the secondary air control Figure 3. (right hand side) and open the primary air control (left hand side) to about half way. See Figure 3. Light the fire and close the door. The room should be kept well ventilated on the first lighting, as there may be an odour and some smoke may be released. -
Page 14: Clearance Of Ash
ClEARANCE OF ASH 5.5.2 REGUlAR CHECKING The ash pan should be emptied on a Remove and clean any fly ash or soot that regular basis and always before it becomes has built up. This should be done on a too full. See Figure 5. If ash is left to build regular basis, about once a month or more up close to the grate, it will cause damage as deemed necessary. -
Page 15: Chimney Fires
CHIMNEY FIRES from debris. If the instructions in this manual are - Ensure that all seals are in good followed and the chimney is cleaned once condition. a year, chimney fires should not occur. - Ensure that air wash openings are clear. Should the chimney go on fire, close both air intakes and ensure the door is fully 7.0 TROUBLE SHOOTING closed. - Page 16 The right is reserved to change specifications, colour, and prices of the models and items illustrated and described in this publication at any time. Whilst every care has been exercised in the production of this catalogue, Firebird cannot accept any liability for errors or omissions. For the latest details always consult Firebird.
Need help?
Do you have a question about the 16" Multifueld Backboiler Inset Stove and is the answer not in the manual?
Questions and answers