Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FireBird Multifuel Backboiler Inset Stove Series
Summary of Contents for FireBird Multifuel Backboiler Inset Stove Series
- Page 1 HEATING SOLUTIONS Multifuel Backboiler Inset Stove Instruction Manual...
-
Page 3: Table Of Contents
INDEX Page INTRODUCTION ..................IMPORTANT SAFETY NOTES ............... TERMS & CONDITIONS OF WARRANTY ........INSTAllATION INSTRUCTIONS Performance ..................Health and Safety ................Air Supply ..................Fireplace ..................... Hearth ....................Chimney/Flue .................. Installing and Back Filling ............Heating and Hot Water System .......... -
Page 4: Introduction
1.0 INTRODUCTION We would like to thank you for purchasing a high efficiency, Firebird multifuel backboiler inset stove (hereinafter referred to as “the inset stove”). The design for this product stems from our original concept, “the Firebird backboiler”. The stove is manufactured in its entirety in our factory in Baile Mhic Íre, Macroom, Co. -
Page 5: Terms & Conditions Of Warranty
(g) Firebird’s prior authorisation must be obtained before examination or repair of the inset stove takes place. (h) Firebird will examine all claims made under the warranty and for any claims deemed invalid, costs incurred will be borne by the householder. -
Page 6: Installation Instructions
4.0 INSTALLATION INSTRUCTION PERFORMANCE The following highlights the output and test performance of the inset stove: Firebird 16” Multifuel Backboiler Inset Stove Fuel Type Wood Ancit Ancit Output to Water - kW Output to Space - kW Efficiency - % 79.9... -
Page 7: Health And Safety
Failure to do intended purpose. so could result in smoke filling into the room or blackening of glass. NOTE: If your Firebird inset stove is not installed, operated and maintained Air Requirements properly a house fire may result! -
Page 8: Fireplace
Please order a room sealed kit from no less than 4.5 meters, vertically from the Firebird to ensure air tightness is achieved top of the appliance to the top of the NOTE: Only Firebird’s room sealed kit can chimney, is required. -
Page 9: Installing And Back Filling
This avoids possible fire risk. 5. Make the connections to the boiler and ensure the primary flow pipe rises Firebird recommend that a thorough from the boiler so that no air is inspection of the chimney is carried out trapped in the boiler. - Page 10 atmosphere, above the height of the instructions are adhered to at all header tank. There should not be any times. valves between the inset stove and 12. All voids must be filled and the flue the vent pipe outlet and it must not pipe flaunched into the chimney, be possible to obstruct the outlet in so that no soot can collect when...
- Page 11 Fireplace surround Inset stove Inset facia Fixing screws for 16" inset min 350 mm for 18" inset min 400 mm min 415 to open door limiting dimensions of hearth Typical installation...
- Page 12 TYPICAl SCHEMATICS Open vent 22 mm Open vent 22 mm Overflow Overflow Cold water Feed and expansion tank tank Domestic hot water draw off Gravity radiator Drain cock Gravity return 28 mm Indirect hot water cylinder Minimum return thermostat Gravity flow 28 mm Central heating flow Circulating pump Back...
-
Page 13: Heating And Hot Water System
HEATING AND HOT The following checks should be carried out WATER SYSTEM prior to lighting a fire in the inset stove: The central heating system must comply with BS5449 part 1. 1. The fire grate is in place. The hot water cylinder must be indirect 2. -
Page 14: Operating Instructions
OPERATING Wood that has been contaminated or treated with varnish, paint or other INSTRUCTIONS coatings and preservatives, should not be used. Not only does it release noxious FUElS chemicals into the air, but it can also HETAS Ltd. approval covers the burning of contribute to the amount of tar and the following smokeless fuels in this inset deposits building up in your chimney. -
Page 15: Smokeless Fuel
The following can be used as a starting Figure 3. base for settings: Coal - primary air set on 3; secondary air set on 1. Wood - primary air set on 1; secondary air set on 3. Please note however, that these may differ with respect to fuel quality and draught. -
Page 16: Clearance Of Ash
ClEARANCE OF ASH 5.5.2 REGUlAR CHECKING The ash pan should be emptied on a Remove and clean any fly ash or soot that regular basis and always before it becomes has built up. This should be done on a too full. See Figure 5. If ash is left to build regular basis, about once a month or more up close to the grate, it will cause damage as deemed necessary. -
Page 17: Chimney Cleaning
thoroughly and open the primary air potentially dangerous and must not be control slightly. tolerated. If fume emission does persist, then the following immediate action This will help to prevent condensation, should be taken: and hence corrosion. 1. Open all windows and doors to CHIMNEY ClEANING ventilate the room. -
Page 18: Spare Parts
SPARE PARTS REDUCING BlACKENING OF GlASS For spare parts please contact Firebird directly on the following numbers: This stove is designed with an air wash, the function of which is to reduce deposits on Ireland: +353 (0)26 45253 the glass. Please note that certain fuel Northern Ireland: +44 (0)28 30888330 types can cause blackening of glass. -
Page 19: Warranty Registration
8.0 WARRANTY REGISTRATION HEATING SOLUTIONS Please complete the following details and return to Firebird to register your Firebird Multifuel Inset Backboiler Stove warranty. HOUSEHOlDER INSTAllER Name: Name: ............... .. - Page 20 The right is reserved to change specifications, colour, and prices of the models and items illustrated and described in this publication at any time. Whilst every care has been exercised in the production of this catalogue, Firebird cannot accept any liability for errors or omissions. For the latest details always consult Firebird.
Need help?
Do you have a question about the Multifuel Backboiler Inset Stove Series and is the answer not in the manual?
Questions and answers