Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet Equinox Fuel Cell Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high,
push the turn signal lever away from you. To change
from high beam to low beam, pull the turn signal
lever towards you. To flash the high beams from low
beam, pull the turn signal lever all the way towards you.
Then release it.

Flash-to-Pass

This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To flash the high beams from low beam, pull the turn
signal/multifunction lever all the way towards you.
Then release it.
3-8
When the high beams are
on, this light on the
instrument panel cluster
will also be on.

Windshield Wipers

Be sure to clear ice and snow from the wiper blades
before using them. If the wiper blades are frozen to the
windshield, gently loosen or thaw them. If the blades
do become damaged, install new blades or blade
inserts. See Windshield Wiper Blade Replacement on
page 5-12.
Heavy snow or ice can overload the wiper motor. A
circuit breaker will stop the motor until it cools down.
Clear away snow or ice to prevent an overload.
Use the lever on the right side of the steering column to
operate the windshield wipers.