Table of Contents
Advertisement
Chapter 10
You can record and playback your performance much like a tape recorder.
This function can greatly enhance your composition and performance results.
1. Recording a Performance
2. Notes about Recording
You can easily replace all or part of a saved User Song.
First, select the User Song (U1 to U4) that you'd like to modify.
1) To record over your song from the beginning:
Press the [Record] button and then the [Play/Stop] button.
Your new performance will replace the existing one from the beginning until you press the
[Play/Stop] button.
2) To replace only part of your song:
Press the [Play/Stop] button and listen to your song.
When you come to the part you want to replace, Press the [Record] button and play your new
part. The M-1 will continue to erase all the notes that were present in the song until you press
the [Play/Stop] button again to exit recording.
1) Press the [Rhythm] button then select a rhythm
using the [Next] and [Previous] buttons or the
"[Rhythm] button + key" method.
If you do not want to record with a rhythm, select
No. 30 "NoDrumSong" as the rhythm (see page 20).
2) Press the [Record] button. The display will scroll
"BEGIN RECORDING".
3) Then press the [Play/Stop] button. The selected
rhythm will begin playing and the recording will
begin immediately. Or, if the metronome is enabled,
a lead in count of one measure will be heard before
recording begins.
4) Play your performance then press the [Play/Stop]
again to stop recording.
5) Now the display will scroll "PRESS RECORD TO
SAVE AS U1". You can use the [Next] or [Preious]
buttons to select the User Recording (from U1 to
U4) to store the recorded song into.
Then, press the [Record] button to store the song,
or any other button to exit the recording.
6) To delete recorded songs, execute "Hard Reset" in
the Function Mode.
2 1
Recording
Advertisement
Table of Contents
