Object Size
Sensitivity
Motion Area Setup
4-2.1.1 MOTION AREA SETUP
The motion detection has been divided into 16x12 grids. The default detection area is
full screen as it marked in transparent for local DVR and purple for remote access.
Areas deselected for motion detection are marked in red for both local and remote sit
e.
Item
Mask Mouse Selection
All Area Detection
Mask All Area
Continue
Exit & Save
Exit & Discard
4-2.2 SENSOR SETUP
Drag the white bar or press ◀ ▶ to set up Object Size
from value 1 to 15 for each channel. The lower value
you set the higher sensitivity it will be. Value set up as 1,
the motion will be detected easiest.
Drag the white bar or press ◀ ▶ to set up Sensitivity from
value 1 to 15 for each channel. The lower value you set
the higher sensitivity it will be
Enter to setup motion detection area
Switch between "select" and "deselect" for cursor-dragging function
Select entire screen as detection area.
Deselect entire detection area.
Continue setup
Save setup and leave
Cancel setup and leave
Description
24