General Safety Instructions; Usage Of Chemical Products - Waterco POOL HEAT PUMP User And Care Manual Manual

Record your model's information.
Keep this manual and your original proof of purchase receipt for warranty and future
references.
On the base of your pool heat pump is a name plate which contains information such as
model number, serial number and electrical information.
Please write these down below and have them handy in case of a service call request.
_______________________________________________________
Number
_______________________________________________________
Serial Number
_______________________________________________________
Purchase Date
_______________________________________________________
Dealer Name
_______________________________________________________
Dealer Address
_______________________________________________________
Dealer Phone
To find detailed product information, the location of the nearest dealer or to register your
pool heat pump, please visit our website www.waterco.com

GENERAL SAFETY INSTRUCTIONS

We have provided important safety messages in this manual and on your pool heat
pump. Always read and obey all safety messages.
This is safety alert symbol.
This symbol alerts you to hazards that can kill or hurt you and others.
This is a very important label.
This symbol alerts you of instructions that MUST be followed properly in order to
ensure that your warranty will not be voided.
IMPORTANT
These are instructions that must be respected in order to protect the user's health
and to ensure that your warranty will not be voided.
and select your location.
GENERAL SAFETY INSTRUCTIONS
All electrical connections must be carried out by a qualified electrician, according to the local
electrical codes. Always cut off the unit's main power whenever the access panel is open or
removed. It is strongly recommended that the pool heat pump is installed outdoors (unless
approved by the manufacturer), while respecting the minimal clearances needed for proper
operation and heating. Please refer to the section "Location" on the following page.
IMPORTANT
Proper pool chemistry is vital to the longevity of your pool heat pump. Pay a particular attention
to the total alkalinity and total dissolved solids. It is highly recommended that you have your
pool chemistry checked often by an outside independent pool store. Your pool water chemistry
must be maintained at all times, as shown in the table below, to prevent damage to your pool
heat pump.

Usage of Chemical Products

Never add liquid chlorine, granular chlorine or slow dissolving tablets/pucks into the skimmer
basket. This high concentration of chemicals should be avoided.
Water quality standards that must be strictly adhered to*:
DESCRIPTION
NORMAL RANGE*
PH Level
7.4 to 7.8
Chlorine Concentration
1.0 to 4.0 PPM
Total Alkalinity
100 to 120 PPM
Total Dissolved Solids
Below 1800 PPM Reg. Pool
Below 3500 PPM Salt. Pool
Calcium Hardness
200 to 300 PPM
* Warranty can be voided if not maintained within these ranges.
MAKE SURE THE INSTALLATION WAS CARRIED OUT ACCORDING TO THE
INSTRUCTIONS OF THIS MANUAL. SEE "INSTALLATION" SECTION.
MAKE SURE YOUR POOL HEAT PUMP WAS PROPERLY GROUNDED AND BONDED.
SEE "BONDING" AND "BONDING DIAGRAM" SECTIONS.
BEFORE ASKING FOR ASSISTANCE OR SERVICE, PLEASE READ CAREFULLY THE
SECTIONS ON "TROUBLESHOOTING" AND "WARRANTY".
Pool Heat Pump | Pg 04
VERIFY
1 per week
1 per 2-3 days
1 per 2-3 weeks
1 per month
1 per month
1 per month