Related Manuals for Urban choice ECO 83A
Summary of Contents for Urban choice ECO 83A
-
Page 1: Instructions For Use
INSTRUCTIONS FOR USE ECO 83A THE LOW CARBON DRYER IMPORTANT PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE. KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE. - Page 2 SECTION 1: BEFORE USE * Safety warnings * User Information SECTION 2: INSTALLATION * Venting * Prior to Installation * Positioning and Air Supply * Final Installation SECTION 3: TECHNICAL SPECIFICATIONS SECTION 4: CONTROL PANEL * The Timer * Heat Switch * Heater Neon * Anticrease Neon * Start Button...
- Page 3 SECTION 1: BEFORE USE * User Information - WARNING: Never stop a tumble dryer before the end of a drying cycle unless all items are quickly removed and spread out so that heat is dissipated. - Clean the lint filter after each drying cycle or the restrictions to airflow will extend drying times and could cause the limit thermostat to stop the burner firing for the remaining part of the drying cycle.
- Page 4 SECTION 2: INSTALLATION (Cont) Fixed Rear Venting. Venting through a hole at the bottom of the back panel. A vent hose must always be used to vent the warm damp exhaust air. The best solution is to make a permanent connection through either a wall or a window. This is particularly recommended for small, cool rooms and a kit for this purpose is available as an accessory.
- Page 5 If you wish to change the side on which your door opens, see Section7 - Door Reversal. Remove any dust by wiping the drum and door with a damp cloth. Any initial smell of burning will be caused by dust on the heater and will quickly disappear.
- Page 6 SECTION 5: DRYING YOUR LAUNDRY (CONT) * Drying When starting the dryer for the first time, or starting after temporary disconnection from the gas supply, air in the pipes will prevent ignition. To clear this air, the dryer must be operated by selecting extra dry and pressing start.
- Page 7 SECTION 6: ADDITIONAL INFORMATION * Any Problems? If the clothes are not dry after normal drying time: - Check that you have selected an appropriate programme and heat setting - Check that the lint filter has been cleaned. A blocked filter will restrict the airflow. - Check that the venting system is clear, and the front air inlet is not blocked.
- Page 8 4213 094 79481...
Need help?
Do you have a question about the ECO 83A and is the answer not in the manual?
Questions and answers