Speed Selection; Variable Speed Adjustment - onga ECO800 Owner's Manual

100
Operation
95
75
25
5
The Onga Eco800 comes pre-programmed with the following default speeds:
0
If the default speed settings do not perfectly match the particular installation. They can be adjusted as follows.
1.
2.
3.
100
95
75
25
5
0
Eco800_OM_final
Monday, 12 November 2012 9:13:35 AM

2. Speed selection

Press for low speed
Filtration and
water circulation
Speed / Application
Off button
Press to turn power on/off.
If power is removed, motor will return to the last speed selected when power is restored.
Motor will remember ON/OFF state.

3.Variable Speed Adjustment

, or
Low Med
-
SET
Low
-
High
+
Med
SET
+ +
Low Med
-
SET
c
e o
8 0 0
Press for medium speed
1450RPM
Low
Med
Cleaning with a
suction cleaner
Press and hold button corresponding to speed you wish to change.
High
Hold for 3 seconds and a light should begin to flash.
+
To decrease speed by 50rpm increments with 1000rpm as the
minimum limit
To increase speed by 50rpm increments with 2850rpm as the
maximum limit
To save the current speed setting and return to normal operation mode
Will cancel the change and revert back to the original speed and
return to normal operation mode
Holding all 3 buttons for 3 seconds will reset the speeds to default
High
+
Press for high speed
2400RPM 2800RPM
High
Backwashing
filter.
Operating some
water features such
as jets or waterfalls.
Solar heating
100
95
75
25
5
0
100
95
75
25
5
0
9