KingCraft TBG818 Instruction Manual page 4

■ MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest
performance. Follow instructions for light bulbs and grinding wheel.
■ NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Disconnect all
tools when not in use, before servicing, or when changing attachments, wheels, etc.
■ AVOID ACCIDENTAL STARTING. Be sure switch is off when plugging in.
■ USE RECOMMENDED ACCESSORIES. The use of improper accessories may cause
risk of injury.
■ USE ONLY GRINDING WHEELS that comply with ANSI B7.1 and rated greater than
3600 RPM.
■ DO NOT use wheels with incorrect size holes. NEVER use wheel washers or wheel
screws that are defective or incorrect and NEVER touch grinding wheel or other moving
parts.
■ NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the
wheel is unintentionally contacted.
■ DIRECTION OF FEED. Be aware of wheel rotation direction; never grind without the
work rest being properly set. NEVER grind more than one work piece at a time.
WARNING:
Wheel coasts after being turned off.
■ CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that
is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any other conditions that may affect its
operation. A guard or other part that is damaged must be properly repaired or replaced
by an authorized service center to avoid risk of personal injury.
■ KEEP TOOL DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a clean
cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any
solvents to clean tool.
■ INSPECT TOOL CORDS AND EXTENSION CORDS PERIODICALLY and, if
damaged, have repaired by a qualified service technician. Stay constantly aware of cord
location and keep it well away from the rotating wheel.
■ NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor or
sparking from grinding metal could ignite fumes.
■ USE OUTDOOR EXTENSION CORDS. Use only extension cords with approved
ground connection that are intended for use outdoors and so marked.
■ RISK OF INJURY DUE TO ACCIDENTAL STARTING Do not use in an area where
children may be present.
■ NEVER START THE GRINDER when the wheel is in contact with the work piece.
■ SECURE WORK. Always hold work piece firmly against the work rest.
■ DO NOT USE THE BENCH GRINDER if the flange nut or clamp nut is missing or if
the spindle shaft is bent.
■ FREQUENTLY clean grinding dust from beneath grinder.
■ DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS,
ALCOHOL, OR ANY MEDICATION.
■ ALWAYS STAY ALERT. Do not allow familiarity, gained from frequent use of your
grinder, to cause a careless mistake. ALWAYS REMEMBER that a careless fraction
of a second is sufficient to inflict severe injury.
■ STAY ALERT AND EXERCISE CONTROL. Watch what you are doing and use
common sense. Do not operate tool when you are tired. Do not rush.
■ SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct
other users. If you loan someone this tool, loan them these instructions also.
SAVE THESE INSTRUCTIONS
3