Environmental Protection - KingCraft TBG818 Instruction Manual

WORK LIGHT BULB REPLACEMENT
To remove work light bulb, gently push the bulb into the socket and turn
counterclockwise. To install the new bulb, gently push the bulb into the socket and turn
clockwise.
NOTE: To help prolong the life of the grinding wheel you may want to purchase a
WHEEL DRESSER at your local hardware store. WHEEL DRESSER IS NOT INCLUDED.
Dressing a wheel is done to renew sharpness or to true up the face of the wheel.
To use the Wheel Dresser set the work rest of the bench grinder at a slight angle and
brace the wheel dresser against it. Do not make contact with the grinding wheel until
after you have turned on the motor and the wheel is rotating at full speed. Press the
dresser slightly against the rotating wheel until you get a bite, then move slowly from
side to side across the wheel. A small bite and many passes is better than a big bite and
one pass. Work cautiously; hold the dresser with force on the work rest. Do not use
excessive pressure against the grinding wheel. Proceed slowly until you master the
technique.
SERVICE CENTER
If you have any question in regards to the operation of this power tool or are in need of
a spare part please contact our service center at:
Wachsmuth & Krogmann, Inc.
Tel: 1-888-367-7373
(Business hours Mon-Fri 9:00am - 4:00pm CT)
Website: http://www.wk-usa.com

ENVIRONMENTAL PROTECTION

If the tool should no longer work at all, please make sure that it is disposed in an
environmentally friendly way, by handing it into a public collection point. Please do not
put it with your household waste.
15