Control Knobs; Tempered Glass Surface - KitchenAid KECC027 Use And Care Manual

C

Control knobs

1. Make sure all control knobs are turned
to OFF.
2. Pull the control knobs straight off.
3. Wash control knobs with sponge and
warm, soapy water. Rinse well and dry
with a soft cloth. Do not soak.
4. Replace control knobs by pushing them
firmly into place.
NOTES:
• When cleaning, never use steel wool,
abrasives, or commercial oven cleaners
which may damage the finish. After clean-
ing, make sure all control knobs
point to OFF.
• To prevent moisture from collecting in
control area, do not remove seals under
control knobs. Wipe up spills in control
area as soon as they occur. Moisture can
cause the ignitor switches to fail.

Tempered glass surface

1. Wipe with sponge and warm, soapy
water or paper towel and mild glass
cleaner.
2. Dry with soft cloth.
3. If soap or detergent solutions are used,
rinse thoroughly to prevent filmy residue.
NOTES:
• When cleaning cooktop with knobs
removed, DO NOT allow water to run
down inside unit. When cleaning, never
use steel wool, abrasives, or commercial
oven cleaners which may damage the
finish.
• When cleaning the cooktop or the area
around the burner base, remove the grate
but leave the burner cap in place to
protect the ignitor from possible damage.
If a cleaning cloth catches the ignitor, it
could damage or break the ignitor. If the
ignitor is damaged or broken, the surface
burner will not light.
aring for Your Gas Sealed Burner Cooktop
23