Maintenance; Troubleshooting - EarthWise SF7A501 Operator's Manual

If you drop the unit, carefully inspect it for damage. If the
housing is cracked or handles broken or if you see any
other condition that may affect the unit's operation, contact
your local Authorized Service Center for repairs before
putting it back into use.
CAUTION: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in
contact with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
IMPORTANT: To assure product SAFETY and RELIABIL-
ITY, repairs, maintenance and adjustment should be per-
formed by a qualified service organization, always using
identical replacement parts.
CAUTION: DO NOT POUR OR SPRAY WATER ON THE
BLOWER TO CLEAN. Never let any liquid get inside the
blower. Never immerse any part of the blower into a liquid.
WARNING: For your safety, turn switch "OFF" and remove
extension cord plug from power source before maintaining
your blower.
Problem
- Unit does not run

MAINTENANCE

TROUBLESHOOTING

Possible Cause
- Extension cord not connected to the plug
- Cord not connected to power source
- Switch not in "ON" position
CALL US FIRST !!
Call us first with questions about operating or maintaining this
tool at 1.800.313.5111 between 7:30 a.m. – 4:30 p.m. Eastern
Standard Time, or send emails to earthwise@reelin.com.
Clean out any clippings which may have accumulated in
the unit. When used properly with dry leaves the fan
chamber of your unit should remain clean. If damp earth
and debris are ingested some of the particles may build
up on the inside of the fan chamber. If this happens the
performance of the unit will decrease. This area can be
cleaned out by gently wiping out with a damp rag after
disconnecting from the power source. Your unit should be
stored in a dry place.
Fertilizers and other garden chemicals contain agents
which greatly accelerate the corrosion of metals Do not
store the tool on or adjacent to fertilizers or chemicals.
Make sure the blower is unplugged, then use only mild
soap and a damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the
tool into a liquid.
- Check extension cord is fully connected to blower
- Check extension cord is fully connected to a receptacle
- Check that switch is in the "ON" position
5
Possible Solution