Gas Connection - Hargrove GAS LOGS Installation And Operation Manual

DAMPER STOP
Attach the damper stop clamp to the fireplace
damper blade. Position the clamp to prevent
full closure of the fireplace damper blade.
See Figure 1
If the damper stop provided does not fit, the
installer shall install a permanent damper stop
that will keep the damper open to a minimum
of opening as determined in Table II.
CAUTION
THE DAMPER MUST BE FULLY OPEN
WHEN OPERATING THE GAS LOGS!
EMBER BURNER POSITIONING
1. Turn the gas off.
2. Remove old log lighter, ashes, and all other
materials from the firebox.
3. Center the ember burner on the fireplace floor
with the burner pipe completely visible from the
front. For best results, the ember burner
should be directly under the flue opening with a
minimum of 4" from the front edge of the ember
burner to the fireplace opening.
4. Place the grate over the ember burner so the
front legs of the grate are just in front of the
ember burner pipe. Once the final positioning
is established, mark the burner and grate
position of the floor of the fireplace for
reference points.
proceed with the gas connection.
See Figure 2

GAS CONNECTION

1. The gas supply line should be 1/2" Inside Diameter (ID) up to 30 feet and 3/4" for longer distance.
2. Use the aluminum connector to connect gas supply to the regulator on the burner assembly. When
bending aluminum tubing use proper bending procedures to avoid kinking the tube. Do not use
corrugated flexible tubing; it may cause a whistling noise.
3. Read lighting instructions. Light pilot and check for leaks using soapy water. These controls are
factory preset and will not normally require additional adjustment of the pilot flame. If field adjustment
of the pilot flame is required, remove the pilot adjust cover screw to expose the adjusting screw. Turn
the adjusting screw clockwise.
Remove the grate and
Figure 1
Fireplace
Floor
Ember
Burner
Figure 2
Figure 3
NG
Embers
Sand
4" Minimum
Pedestal
Grate
Grate
Clip
LP
Embers
Vermiculite