Ft. Belt Replacement - King Kutter Free Floating Finishing Mower Owner's Manual

5-6-7 FT. FINISHING MOWER
TO REPLACE BELT:
STEP 1 Remove top cover.
STEP 2 Release adjustment spring.
STEP 3 Loosen nut on adjustment pulley to allow for movement. (See Fig-
ure "D")
STEP 4 Loosen nut on right side of "L" bracket. (See Figure "D")
STEP 5 Loosen belt by moving adjustment pulley in opposite direction you
would to tighten belt.
STEP 6 Remove nuts (2) from hinged gearbox plate from finishing mower
deck. (See Figure E)
STEP 7 Loosen nuts (2) from hinged bolt gearbox plate.
STEP 8 Raise gearbox assembly and slip out belt.
STEP 9 See Figure D for belt placement on pulleys.
STEP 10 Do step 5 thru 7 under Section: "TO ADJUST BELT" to tighten.
TO ADJUST BELT:
STEP 1 Remove top cover.
STEP 2 Release adjustment spring.
STEP 3 Loosen nut on adjustment pulley to allow for movement. (See Fig-
ure D )
STEP 4 Loosen nut on right side of "L" bracket. (See Figure D)
STEP 5 Turn nut on left side of "L" bracket in counter clockwise direction
until belt is tight.
STEP 6 Re-tighten nut on right side of "L" bracket and nut on adjustment
pulley.
STEP 7 Re-hook adjustment spring. (See Figure "D")
22