Ten-Haaft Oyster Vision II Assembly Instructions Manual page 2

ASSEMBLY INSTRUCTIONS
Don't worry – it does not require any witchcraft to assemble the mobile
satellite system Oyster Vision II. Some points should be observed,
however. Please accurately follow these assembly instructions so that
afterwards your unit will operate to your full satisfaction.
If necessary, mounting and operating instructions can also be
downloaded over the internet from www.ten-haaft.de.
Please completely read each point at least once before you begin to
execute it.
In this way, complete point for point successively.
Note:
This is a sensitive device. Do not tear at the dish arm. Do not
manually lift or turn the dish arm; the dish arm may only be
moved by the motor. Only raise at plastic screen or aluminium
plate. The screws at the plastic housing may be loosened only
by the manufacturer of the unit.
Caution:
Never grip into the range of the external unit while it is moving!
Note for operation on caravans/trailers:
The 12 V board system power supply which is generated by voltage
transformers built into caravans as a standard is frequently not stable
enough for the operation of the satellite system.
We recommend the auxiliary transducer which can be ordered from
us for installation into caravans.
2