Ten-Haaft Oyster Vision II Assembly Instructions Manual page 18

Disassembling the system
You can take the system from the roof, e.g. in order to install it separately
with the optionally available ground assembly set.
To disassemble the external system you need a wrench SW 13.
It is not necessary to dismantle the cable.
Proceed as follows:
• Unscrew the 4 nuts M8 with which the system is bolted to the
assembly plate.
• Lift the system a little bit, press on the nose of the 15 pin plug and
pull it off.
• Turn at the BNC plug of the coaxial cable and pull it off.
• Now you can lift off the system.
In order to assemble the system again, proceed in reverse order.
18