Switch Mounting - Dish Network Dish Pro 34 Installation Manual

2. Connect the coaxial cables from a DISH 500 or a DISH
Network bandstacked FSS or DBS LNBF to the ports on the
DP34 switch labeled
begin on page 10).
3. Connect the cables from the DISH Network receiver's back
panel
S
ATELLITE
R
ECEIVER
signals from up to three orbital locations, so you can
route the signals from up to three orbital locations to as many
as four receiver tuner inputs.
Page 6
Figure 1. Switch Mounting
TO
port(s) to the DP34 ports labeled
I
N
. The switch's four outputs each supply
S I
ATELLITE N
Do not connect the receiver to the ports labeled
ADDITIONAL SWITCH
in the system to experience loss of video.
(see also the wiring diagrams that
D
ISH
as this can cause other receivers
TO
T
O