Table of Contents
Advertisement
TG8411_8421BX(e).book Page 46 Tuesday, May 12, 2009 11:52 AM
Useful Information
Problem
I cannot register a handset to a
base unit.
Battery recharge
Problem
The handset beeps and/or )
flashes.
I fully charged the batteries, but
) still flashes.
I fully charged the batteries, but
the operating time seems to be
shorter.
Making/answering calls
Problem
w is flashing.
46
Cause/solution
L The maximum number of base units (4) is
already registered to the handset. Cancel
unused base unit registrations from the
handset (page 29).
L You entered the wrong PIN. If you forget your
PIN, contact your nearest Panasonic service
centre.
L Place the handset and the base unit away
from other electrical appliances.
Cause/solution
L Battery charge is low. Fully charge the
batteries (page 8).
L Clean the charge contacts and charge again
(page 9).
L It is time to replace the batteries (page 8).
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth and charge
again.
Cause/solution
L The handset is too far from the base unit.
Move closer.
L The base unit's AC adaptor is not properly
connected. Reconnect AC adaptor to the
base unit.
L You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L The handset is not registered to the base unit.
Register it (page 28).
Advertisement
Table of Contents
