Table of Contents
Advertisement
TG8411_8421BX(e).book Page 45 Tuesday, May 12, 2009 11:52 AM
Problem
I cannot hear a dial tone.
I do not know how to erase y
(Missed call) from the display.
I cannot use "Copy" or "Copy
All" when I press 1 while
displaying phonebook entries.
Programmable settings
Problem
I have changed the display
language to a language I
cannot read.
While programming, the
handset starts to ring.
While programming, the
display returns to standby
mode.
Useful Information
Cause/solution
L Make sure that you are using the supplied
telephone line cord. Your old telephone line
cord may have a different wiring configuration.
L The base unit's AC adaptor or telephone line
cord is not connected. Check the connections.
L If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the
wall jack directly. If the unit operates properly,
check the splitter.
L Disconnect the base unit from the telephone
line and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to
have the unit repaired. If the working
telephone does not operate properly, contact
your service provider/telephone company.
L There are unviewed missed calls remaining.
View them and erase y in the following way.
1
1 (centre of joystick) i j i M
2
Push the joystick down to search from the
most recent call, or push the joystick up to
search from the oldest call.
L These items are phonebook copy features
between the handsets. Although the handset
shows these items, copy features are not
available for this model.
Cause/solution
L Change the display language.
{ih} i 1 i N i M i Push the
joystick down 2 times. i M i Push the
joystick down 5 times. i M i
{V}/{^}: Select your desired language. i
M i {ih}
L A call is being received. Answer the call and
start again after hanging up.
L A call matching an entry in the call barred list
is being received. Wait and try again later.
45
Advertisement
Table of Contents
