Wire Connection - Valor ITS-301D Operating Instructions Manual

. :...+-
~.
Wire Connection
;\'.,.tOUTCONN¢roR . ' .
DVD Audio Out (GRAY) Rear: White (L) Red (R)
Connect this wire to rear seat AN monitor system to enjoy
DVD movie
Audio Out (Front): White (L) Red (R)
Audio Out (Rear): White (L) Red (R)
Audio Line In : White (L) Red (R)
Subwoofer : Orange
Video Out (Yellow) : Yellow (Plug)
Connect to external AN system to display
Video In (Black) : Yellow (Plug)
Connect to external Video equipment
Rear camera In (Black) : Blue (Plug)
Connect to rear camera output
iPod Cable (White)
Connnect to portable iPod player
CONTROL WIRE
Parking (Gray) : Connect this wire to car hand brake system
Tel mute (Black) : Connect to mobile phone unit
When receiving calls, audio sound will be muted.
Reverse (Red) : Connect to back rear camera
During back gear condition, this wire should be connected to high
voltage.
.
'DRiVlNG:~~~~ Dl$'lAf:~
:, . -
j~t:~; ~
Follow the installation below so when the car is in motion, no video will
come out from the LCD screen. Only sound can be heard from speaker.
Top view
[b~
~l
To Hand brake switch
GRAY
BIB
~
ww"
I
BLACK
c=::J
RED
..
c=::J
FRONT
c=::J
Steps:
SIDE
1. Connect the gray wire to the hand brake
c=::J
system.
c=::J
J 2. Check your hand brake switch and make
sure it is connected to car body chassis and
c=::J
properly grounded.
Note:
- Only sound can be heard when car is in motion.
- Refer and follow your country's law regarding driving with
video.
Caution:
- Do not attempt to install it by yourself if the instruction is not
clear to you. Consult you dealer concerning the installation
procedures.