Toshiba Satellite L20 Series Maintenance Manual page 189

Replacement Procedures
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-21 to
4-24).
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.5×2.0B
• M2.5×6.0B
• M2.5×3.0B
Satellite L20 Maintenance Manual(960-Q01)
FLAT BIND screw
FLAT BIND screw
FLAT BIND screw
x3
x18
x2
185