Assembly; Carton Contents - Generac Portable Products 2400PSI Owner's Manual

ASSEMBLY

IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the handle, high pressure hose, and parts box
included with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
• Roll pressure washer out of carton.

Carton Contents

Items in the carton include:
• Main Unit
• Handle
• High Pressure Hose
• Safety Goggles
• Nozzle Extension with Quick–Connect Fitting
• Oil Bottle
• Spray Gun
• Extension with Turbo Nozzle
• Parts Bag (which includes the following):
• Maintenance Kit
• Owner's Manual
• Engine Manual
• Owner's Registration Card
• Bag containing 4 Multi–Colored Spray Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (4)
• Locknuts (4)
• Spring Clips (2)
• Self Tapping Screws (2)
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1–800–270–1408.
PREPARE PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1–800–270–1408.
Generac Portable Products 2400 PSI Pressure Washer
Perform these tasks to prepare unit:
1.
2.
3.
4.
5.
Attach Handle to Pressure Washer
To attach handle to the pressure washer:
1.
2.
3.
4.
5.
Attach Spring Clips to Handle
1.
2.
6
Attach handle to main unit.
Add oil to engine.
Add fuel to fuel tank.
Connect high pressure hose to spray gun and pump.
Connect water supply to pump.
Slowly tip pressure washer forward and gently rest it
on the front bumper, as shown in Figure 1.
Figure 1 — Attach Handle to Pressure Washer
Align holes on handle with holes on base.
Insert carriage bolts provided to hold handle in place.
Secure handle to pressure washer using the four
provided flange nuts.
Slowly tip pressure washer back in place and insert
multi–colored spray tips in the spaces provided in handle.
Attach spring clips to left side (viewing from rear of unit)
of handle with self tapping screws in holes provided.
Place extension with turbo nozzle in spring clips, as
shown in Figure 2.
Figure 2 — Place Extension with Turbo Nozzle in Spring Clips
Spring Clips