Precautions On Installation Environment - Sony GXD-L65H1 Operating Instructions Manual

Flat wide display monitor
Hide thumbs Also See for GXD-L65H1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 50
Precautions on
installation environment
This display conforms to international dust and splash
proof standard IEC60529 IP54 and so can be used in a
location where a lot of dust particles or splashing
water may be produced.
The performance indicated by the digits after IP is
shown below.
Dust proof
IP5_ Protected against dust.
Definition
Entry of dust is not entirely prevented, but it must not
enter in sufficient quantity to interfere with the safe
and proper operation of the equipment.
Splash proof
IP_4 Protected against splashing water.
Definition
Water splashing against the enclosure from any
direction shall have no harmful effect.
Provide an ample amount of space around
the display
• To prevent internal heat buildup from sealing off
the display, make sure to ensure proper ventilation
by leaving open the minimum amount of space
around the display, as illustrated below.
• The ambient temperature must be 0 °C to 35 °C (32
°F to 95 °F). Be careful when installing the display
near a ceiling. The temperature there can become
much higher than the normal, lower-level room
temperature.
• While the display is on, a certain amount of heat
builds up inside. This can cause burns. Avoid
touching the top or rear of the display when it is
powered on or just after it has entered standby
mode.
When mounting the display horizontally
Front
10
(4
)
Light sensor/Remote control sensor
8
GB
7
25 (9
/
)
8
10
(4
)
7
25 (9
/
)
8
Side
When mounting the display vertically
Front
25
7
(9
/
)
8
Make sure
that the 1
(POWER)
switch is at
the lower
left.
Light sensor/Remote control sensor
Side
Avoid high temperatures and high humidity
If this unit might be exposed to high temperatures or
high humidity when in use, or where the temperature
can change rapidly because of air conditioning or the
like, condensation may form inside the protective
glass of the display monitor.
Do not block the light sensor or remote
control sensor
Do not place anything in front of the light sensor or
remote control sensor.
Doing so may prevent the automatic brightness
adjustment function or the remote control from working.
5 (2
)
Units: cm (inches)
7
20 (7
/
)
8
25
7
(9
/
)
8
10 (4
)
5 (2
)
Units: cm (inches)

Advertisement

Table of Contents
loading

Table of Contents