Connecting The Ac Cable Of The Dc Disconnect To The Inverter - SMA SUNNY BOY 3000-US Installation Manual

SMA America, LLC

6.3.3 Connecting the AC Cable of the DC Disconnect to the Inverter

The power distribution grid is connected to the inverter via the DC Disconnect.
Inserting the AC cable of the DC Disconnect into the inverter
1. Open the inverter (see Section 9.1).
2. In order to insert the AC cable of the
DC Disconnect, pierce a hole in the center of the
rubber grommet in the enclosure opening.
Use a screwdriver for this.
3. Insert the AC cable of the DC disconnect into the inverter through the rubber grommet.
4. Pull back the AC cable of the DC Disconnect slightly. This seals the rubber grommet.
Connecting the AC cable of the DC Disconnect to the inverter
Figure 16: AC connecting terminal plate for connecting the AC cable of the DC Disconnect
Position
A
B
C
D
Installation Manual
Designation
Screw terminal "L1"
Screw terminal "L2"
Screw terminal "N"
Screw terminal
6 Electrical Connection
SB30-40-US-IA-en-33 41